IAI America IX-NNW8040 - Manual (Page 51)

45
6. Inspection/Maintenance
(5) Affix the cover (base) using the hex bolts [1] and sealing washers (six pieces each) (tightening torque:
0.74 N-m).
z When installing the cover (base), be careful not to pinch the cables inside.
z Disassembling the cover provides opportunities for water and powder dust to enter the robot.
Always disassemble the cover in an appropriate environment where water/powder dust will not
enter the robot.
[1] 6 - M3 x 6
Caution
Affix one side of the cover (base) first,
and then tighten the mounting bolts on
the opposite side while pressing the
cover against the curve along the
contact surface of the base.
Confirm that no gaps remain between
the cover (base) and gasket.
Sealing washer
Cover (base)