IAI America IX-NNW8040 - Manual (Page 73)

67
7. Specifi
cations
Item Specifications
0 to 40 C
Altitude m 1,000 or less
B d e s i o N 74
Robot weight kg 60
230 V 50/60 Hz 15 A
Allowable supply voltage fluctuation % 10
Overvoltage category (IEC60664-1) Category III
Pollution degree (IEC60664-1) Pollution degree 3
*1 To move the robot horizontally at high speed, perform teaching so that the vertical axis stays as close to the top
position as possible. (Fig. 1)
To operate the robot with its vertical axis at the bottom position, the speed and acceleration must be reduced as
appropriate. (Fig. 2)
*2 Assuming PTP instruction operation.
*3 Measured at a constant ambient temperature of 20 C.
*4 Measured when the robot is operated at the maximum speed, carrying a rated load of 5 kg.
*5 The permissible moment of inertia converted to a value at the rotational center of axis 4. The offset from the
rotational center of axis 4 to the tool’ s centerof gravity is assumed to be 50 mm or less. (Fig. 3)
If the tool’ s center of gravity is furt
her away from the rotational center of axis 4, the speed and acceleration must be
reduced as appropriate.
*6 If the tool exceeds the permissible diameter, it will contact the robot inside the robot’ s range of movement. (Fig. 4)
*7 To enable the alarm LED indicator, the user must provide a circuit that supplies 24 VDC to the LED terminal in the
user connector in response to the controller I/O output signal, etc.
*8 A force of up to three times the dynamic push-in thrust may be applied at any given moment.
*9 The static thrust refers to thrust generated within the robot’ s range of operation based on a PAPR command.
*10 The robot will exhibit the dust-proof/splash-proof performance when air compressed to 0.2 to 0.3 MPa is supplied
from the air inlet.
The dust-proof/splash-proof specification provides a dust-proof/splash-proof structure against water and powder
dust conforming to the IEC standard and protection class IP65. Please note that the dust-proof/splash-proof
specification is not explosion-proof.
*11 The controller is not dust-proof or splash-proof.
Reference design standards: Annex I to Machine Directives, EN292-1, EN292-2, EN1050, EN60204-1, EN775
Top position
Tool
Tool
Tool
Tool
Bottom
position
Center of
rotational axis
Center of
rotational axis
Tool’ s center of
gravity
(Fig. 1) (Fig. 2) (Fig. 3) (Fig. 4)
50
100
Brake power source for main unit W 24V DC ±10% 20W
Controller (*11) Power supply
Operating
environment Ambient temperature