IAI America XSEL Ethernet - Manual (Page 31)

- 25 -
[I/O parameters]
No. Parameter name Setting Input range Remarks
124 Network attribute 5 (MANU
mode)
1H or
3H
(AUTO
mode)
10H or
30H
0H~FFFFFFFFH Ethernet TCP/IP message communication attribute
Ethernet client/server type
0: Do not use
1: Client (Assign own port number automatically)
(2: Client (Specify own port number)

This setting is not recommended in view of
the associated device restrictions, such as a
forced-error detection if the port is opened
for approximately 10 minutes in a condition
where a close response cannot be confirmed
due to a power failure in the connected
device, etc.)
3: Server (Specify own port number)
* Note: Number of clients that can be
connected to one server-port channel
simultaneously = 1
Bits 0 to 3: IAI protocol B/TCP (MANU mode)
* PC software connection is enabled in the client
mode only.
Bits 4 to 7: IAI protocol B/TCP (AUTO mode)
* PC software connection is enabled in the client
mode only.
Bits 8 to 11: User-open channel 31
Bits 12 to 15: User-open channel 32
Bits 16 to 19: User-open channel 33
Bits 20 to 23: User-open channel 34
* IAI protocol B/TCP MANU/AUTO
The connection will be cut off briefly during
switching between the MANU and AUTO modes, if
the parameter settings of “own port number,”
“client/server type,” “IP address of connection
destination” and “port number of connection
destination” do not fully correspond between the
two modes.
… … … … …
129 Network attribute 10 10H 0H~FFFFFFFFH
Ethernet operation requirement
Bits 0 to 3: Remote I/O
0: Do not use
1: Use Modbus/TCP (EXCEPTION status
invalid)
2: Use Modbus/TCP (EXCEPTION status valid)
3: Use EtherNet/ IP (main application version
1.05 or later)
Bits 4 to 7: TCP/IP message communication
0: Do not use
1: Use
Bits 8 to 31: Not used
130 Own MAC address (H) 0030H
Reference value
(HEX)
Only the lower two bytes are valid. (This parameter is
not settable.)
131 Own MAC address (L) 11H
Reference value
(HEX)
(This parameter is not settable.)
132 Own IP address (H) 192 1~255 * Setting of “0” and “127” is prohibited.
133 Own IP address (MH) 168 0~255
134 Own IP address (ML) 0 0~255
135 Own IP address (L) 1 1~254 * Setting of “0” and “255” is prohibited.
136 Subnet mask (H) 255 0~255
137 Subnet mask (MH) 255 0~255