IAI America XSEL Ethernet - Manual (Page 35)

- 29 -
c. Selecting the controller
Entering the port number and clicking the [OK] button switches the display to the Select
Controller screen.
Figure 3
Each time a connection is established from a controller, the IP address of the connecting
controller is added to the list. Select the IP address of the controller with which you want to
communicate, and then click the [OK] button. Communication will be established with the
selected controller and the application will start in the online mode.
Clicking the [CANCEL] button will activate the offline mode. (Even after the application is started
in the offline mode, you can still switch to the online mode through “reconnection.”)
If the checkbox “The controller connected will be chosen automatically next time” is selected,
the application will automatically establish connection with the controller that was connected
first.
* Check this option only when you are communicating with a single controller or using
peer-to-peer connection.
d. Changing the connection destination
If you want to switch between multiple controllers, the connecting controller can be changed via
the following procedure.