IAI America XSEL Ethernet - Manual (Page 54)

- 48 -
Setting requirement
A: Required (function selection)
B: Required (network environment, etc.)
C: Checked (As a rule, the default value
on the parameter list must be used.)
Modbus/
TCP
IAI protocol
B/TCP
Transmission by
SEL program
No.
Parameter
name
Default
value
(reference)
Input range Unit Remarks
C C C 125
Network
attribute 6
1E32H 0H~FFFFFFFFH
Bits 0 to 7: Module initialization check timer value when Ethernet
is used (100 msec)
Bits 8 to 15: Module initialization check timer value when
Ethernet is not used (100 msec)
Bits 16 to 23: Increment of “PC/TP reconnection delay time upon
software reset” when Ethernet is used (sec)
C C C 126
Network
attribute 7
7D007D0H 0H~FFFFFFFFH
Ethernet TCP/IP message communication attribute
Bits 0 to 15: Min timeout value (msec)
Bits 16 to 31: Mout timeout value (msec)
C C C 127
Network
attribute 8
5050214H 0H~FFFFFFFFH
Ethernet TCP/IP message communication attribute
Bits 0 to 7: CONNECT_TIMEOUT (sec) * Changes to this
setting are prohibited.
Bits 8 to 15: Connection retry interval (sec) (IAI protocol B/TCP)
Bits 16 to 23: Send timeout value (sec)
Bits 24 to 31: IAI protocol B-SIO non-communication check timer
value (sec)
(IAI protocol B/TCP connection trigger)
C 128
Network
attribute 9
0H 0H~FFFFFFFFH
Ethernet TCP/IP message communication attribute
Bits 0 to 15: SEL server open timeout value (sec)
(No timeout check when “0” is set)
A A A 129
Network
attribute 10
0H 0H~FFFFFFFFH
Ethernet operation requirement
Bits 0 to 3: Remote I/O
0: Do not use
1: Use Modbus/TCP (EXCEPTION status invalid)
2: Use Modbus/TCP (EXCEPTION status (upper two digits
of error number) valid)
3: Use EtherNet/IP (main application version 1.05 or later)
* Handle each error according to the error level by
referring to the explanation of error level in the
operation manual.
Bits 4 to 7: TCP/IP message communication
0: Do not use
1: Use
Bits 8 to 31: Not used
130
Own MAC
address (H)
0H
Reference only
(HEX)
Only the lower two bytes are valid.
131
Own MAC
address (L)
0H
Reference only
(HEX)
B B B 132
Own IP
address (H)
192 1~255 * Setting of “0” and “127” is prohibited.