LevelOne FCS-1091 - Manual (Page 12)

8
Installation - FCS-1091/WCS-1090
1. Assemble the Camera
Attach the lens to the FCS-1091/WCS-1090. On the WCS-1090, screw the
antenna to the rear mounting point, and set the antenna to the upright position to
improve wireless reception.
2. Connect the LAN Cable
Connect the FCS-1091/WCS-1090 to a 10/100BaseT hub or switch, using a
standard LAN cable.
For WCS-1090, plugging in the LAN cable will disable the
Wireless interface. Only 1 interface can be active at any time.
The LAN cable should only be connected or disconnected
when the camera is powered OFF. Attaching or detaching the
LAN cable while the camera is powered on does NOT switch
the interface between wired and wireless.
The first time you connect to the camera, you should connect
the LAN cable and configure the FCS-1091/WCS-1090 with
appropriate settings. Then you can unplug the LAN cable and
power off the camera. The WCS-1090 will be in wireless
interface when you power on the camera again.
3. Power Up
Since FCS-1091 is a PoE IP camera, it could work without attaching to power
outlet as long as it connects to PoE switch.
Connect the supplied 12Vpower adapter to the FCS-1091/WCS-1090 and power
up. Use only the power adapter provided. Using a different one may cause
hardware damage.
4. Check the LEDs
• The
Power LED will turn on briefly, then start blinking. It will blink during startup,
which takes 15 to 20 seconds. After startup is completed, the Power LED should
remain ON.
• The
Network LED should be ON.
For more information, refer to Physical Details - FCS-1091/WCS-1090 in Chapter 1.