LevelOne FCS-1091 - Manual (Page 33)

29
Chapter 5
Web-based Management
This Chapter provides Setup details of the FCS-1091/WCS-1090’s
Web-based Interface. This Chapter is for the Camera Administrator
only.
Introduction
The FCS-1091/WCS-1090 can be configured using your Web Browser. The FCS-
1091/WCS-1090 must have an IP address which is compatible with your PC.
The recommended method to ensure this is to use the supplied Camera Wizard, as
described in Chapter 2 - Basic Setup.
Connecting to FCS-1091/WCS-1090
• If using only your Web Browser, use the following procedure to establish a
connection from your PC to the FCS-1091/WCS-1090:
• Once connected, you can add the FCS-1091/WCS-1090 to your Browser's
Favorites or Bookmarks.
Connecting using your Web Browser
1. Use the Camera Wizard to get the IP address of the FCS-1091/WCS-1090.
2. Start your WEB browser.
3. In the Address box, enter "HTTP://" and the IP Address of the FCS-1091/WCS-
1090.
4. You will then be prompted for a username and password.
• If using the default values, enter administrator for the name, and leave the
password blank.
• Otherwise, enter the Administrator ID and Administrator Password set on the
Maintenance screen.
5