LevelOne MSL-3S79 - Manual (Page 75)

69
stp-admin- stp
[disable|enable]
Interface
configuration
mode
Use the stp-admstp interface
configuration command to
configure a port controlled by
stp protocol.
Enable switch (config)#interface
gigaethernet 1
switch(config-if)# stp-admin stp
enable
40B
VLAN Commands Set
Commands
Command
Level
Description Default Example
vlan database Privileged
EXEC
Enter VLAN configure mode switch#vlan database
switch(vlan)#
vlanmode
[portbase| 802.1q|
gvrp ]
VLAN database
mode
To set switch VLAN mode. 8021q switch(vlan)#vlanmode
portbase
or
switch(vlan)#vlanmode 802.1q
or
switch(vlan)#vlanmode gvrp
show vlan
or
show vlan
[GroupName|
VLAN ID] VLAN database
mode
Show VLAN information switch(vlan)#show vlan
or
switch(vlan)#show vlan 2
Port Base VLAN mode
no vlan group
[VLAN ID] VLAN database
mode
Delete port base group ID switch(vlan)#no vlan group 2
vlan port-based
grpname
[Group Name]
grpid
[VLAN ID]
port
[PortNumbers]
VLAN database
mode
Add new port based VALN switch(vlan)#vlan port-based
grpname test grpid 2 port 2-4
or
switch(vlan)#vlan port-based
grpname test grpid 2 port 2,3,4
802.1Q | 802.1Q with GVRP VLAN mode*
vlan 8021q name
[GroupName] vid
[VLAN ID] media
VLAN database
mode
Change the name of VLAN
group, if the group didn’t exist,
this command can’t be applied.
switch(vlan)#
vlan 8021q name RD vid 2
media gigaethernet state