LevelOne MSL-3S79 - Manual (Page 86)

80
show lldp remote Privileged
EXEC
Show LLDP remote table. switch# show lldp remote
lldp-port [disable
|rx|tx|both]
Interface
configuration
mode
Use those commands to set
lldp port tx and rx mode.
Disable switch(config)# interface
gigaethernet 1
switch(config-if)# lldp-port
disable
or
switch(config-if)# lldp-port rx
50B
ACL Commands Set
Commands
Command
Level
Description Defaults Example
acl-port
[deny|permit]
or
no acl-port
Interface
configuration
mode
Use the acl-port interface
configuration command to
enable Access Control on a
port. The default action can be
Deny or Permit. Use the no
form of this command to return
the port to its default value
(disable).
Disable switch(config)# interface
gigaethernet 1
switch(config-if)#
acl-port deny
or
switch(config-if)#
no acl-port
acl-rule [index] dst
[dstIp/prefix] src
[srcIp/prefix]
{deny|permit}
or
no acl-rule [index]
Interface
configuration
mode
Use those commands to add or
delete the acl rules of the port.
[index] range= 0~4
N/A switch(config)# interface
gigaethernet 1
switch(config-if)#
acl-rule 0 dst 192.168.16.1/32
src 192.168.16.2/32 permit
or
switch(config-if)#
no acl-rule 0
show acl
[gigaethernet|port-
channel][port]
Privileged
EXEC
Show acl configuration of the
port.
N/A switch# show acl gigaethernet
1