ARCHOS AV420 - Manual (Page 25)

25
the Infrared Emitter stuck to your device and turn your device on and
off. Click this test button again and your device should change from on
to off or off to on. If pressing this button does not turn on and off your
device, try the next code for your device (step 3 above). If none of the
codes work, check that the infrared emitter is directly over the infrared
sensor on your tuner device.
Note: In some rare cases the ON/OFF functionality may not work.
Parameter Description
Key: -/-- Set this to On if normally, you have to press this same key on
your device’s remote control in order to select a channel.
Number of digits Set the number of digits that your device can recognize for a
channel. Example: Set to 3 if you need to choose a channel
greater than channel 99.
Key: Enter Set this to On if normally, you have to press the Enter key
on your device’s remote control after you enter the channel
number. Example: If you normally press 1, 3, Enter for
channel 13, then you would need to set this parameter to On.
Key Delay Change the delay between the emission of each digit of a
channel. You may need to adjust this if the AV400 seems
to send only half the digits of a channel or more digits of a
channel. Example: Adjust the key delay and retest channel
select if it sends channel 1 instead of 12 or sends 112 instead
of 12.