ARCHOS AV420 - Manual (Page 58)

58
Macintosh™ OS X
If you have OS X, you must update to version
10.2.4 or newer. This is a free update from Apple
®
Computer. You must also change the AV400’s
USB Port setting to ‘
Hard Drive’. From the main
menu, go to Setup > Settings > USB Port and
change the setting to ‘
Hard drive’. You will now
simply plug the AV400 into your Macintosh ® as
enumerated above, and within a few seconds, the
AV400 will be recognized as a mass storage device
(Hard Disk) and mount on the desktop. You can
now use the Hard disk called JUKEBOX like any other external hard disk.
17.3
Disconnecting the AV400 from your Computer
Windows Device Mode
Verify that no data is being transferred between your AV400 and your
computer (the HDD light on your AV400 is not flickering). You can now
safely unplug the USB cable from your AV400 and/or computer.
Hard Drive Mode
DO NOT SIMPLY PULL OUT THE USB CABLE AT ANY TIME!
WARNING: You must properly remove (unmount) your AV400 from the
computer before disconnecting the USB cable to avoid loss of data or
freezing the computer and/or the AV400.
Windows ®
To safely disconnect the AV400 hard disk, click on the system tray remove
icon (green arrow as shown below) and follow the instructions. Wait until
you get a message saying that you can safely unplug the device before
disconnecting the USB cable.