Acer Altos G700 series - Manual (Page 54)

3 Upgrading the system 44
Installing a 5.25-inch storage device (optional)
Note: If you are installing a new drive in an empty drive bay, skip
steps 2 to 4.
1 Observe the ESD precautions and pre-installation procedures
described on page 31.
2 Disconnect the power and IDE cables from the old drive.
3 Press the release bracket on both sides of the drive carrier (1)
before pulling it out from the chassis (2).
4 Remove the eight screws that hold the old drive to the drive
carrier then pull it out.
AA G701 - EN.book Page 44 Tuesday, February 25, 2003 5:19 PM