Teledyne LeCroy WaveExpert series Automation Manual - Manual (Page 283)

A PPENDIX - A DCOM Setup
C) Testing the DCOM Connection from the PC
Note: Only attempt to test the DCOM Connection from the PC after both the PC and Oscilloscope have been set for DCOM configuration.
Let’s test the DCOM Connection from the PC to the Oscilloscope using the following steps:
1. If not already done, install XStream Browser.
2. Launch
the
XStream Browser
application on the PC. Make sure that the version of the software is at least
1.0.3 by verifying from the Help/About screen – Help (Menu Bar) Æ About.
3. On the
XStream Browser
screen, click File Æ Connect to Remote Instrument (DCOM).
4. The
Network Address of DCOM-enabled Instrument
dialog is shown. Provide the Scope Name or its IP
Address
and click OK.
A-
916435 RevA
26