Teledyne LeCroy SierraNet M408 User Manual Ver.1.40 - Manual (Page 20)

Teledyne LeCroy Expandability
18 SierraNet M408 User Manual
6. Repeat steps 4 and 5 approximately three times, until the card is free from the
retaining screws and you can remove the card from the system.
1.4.2 Cascading with CATC SYNC Expansion
You can use cascading of analyzer units for higher port count, by connecting the units
through the optional CATC SYNC Expansion Card on the analyzer back.
Connecting Two SierraNet M408 Analyzers via the CATC Sync Expansion Card (ACC-EXP-
002-X)
Multiple SierraNet M408 Analyzers can be connected using their CATC Sync ports which
require an optional expansion card (ACC‐EXP‐002‐X).
Note: Refer to relevant protocol analyzer user manual for instructions on how to install the expansion
card.
To do so perform the following steps:
1. Make sure to stop any recordings in progress.
Note: You may plug/unplug the sync cable while the analyzer unit is powered on.
2. Connect the female end of the sync cable to the SYNC OUT port of one SierraNet
M408.