Teledyne LeCroy SierraNet M408 User Manual Ver.1.40 - Manual (Page 222)

LeCroy Corporation Scenario Example
220 SierraNet M408 Protocol Analyzer User Manual
Figure 4.16: Naming a Scenario
Adding a Sequence
To add a Sequence click Add State in the Sequence 1 panel.
You create a sequence one state at a time. The application numbers states consecutively
from 0 up (1, 2, 3, and so on).
By default, the name of the first sequence in a Scenario is Sequence 1. The name of the
first state is State 0. To change the name of a sequence or state, or to associate a
description with it, click the name of the sequence or state..
1. Drag 6‐Byte Any SCSI Command under FCP as the Event to display the dialog.
Figure 4.17: Adding an Event for Sequence 1
2. Click OK to close the 6‐Byte Any SCSI Command dialog box.
3. After adding an Event, to add an Action in the Sequence 1 panel, drag and drop
Monitor/Count.
The Monitor/Count dialog box displays (see
Figure 4.18 on page 221 ).