Teledyne LeCroy SierraNet M408 User Manual Ver.1.40 - Manual (Page 76)

Teledyne LeCroy Trigger and Filter Settings in Easy Mode
74 SierraNet M408 User Manual
Auto Calibration
Click the Auto Calibration Settings.... button to display the Auto Calibration dialog.
Figure 2.45: Auto Calibration Dialog
Set the parameters for the following:
 Port # ‐ Select the port.
 Time Intervals(ms) ‐ Select the time interval from the drop‐down list.
 Target Eye Width(%) ‐ Select the target eye width from the drop‐down list.
 Fine Tune Threshold(%) ‐ Select the fine tune threshold from the drop‐down list.
 PRBS Type ‐ Select value from the drop‐down list.
 Status ‐Progress bar indicating the status of calibration.
 Calibrate ‐ Select Transceiver, Splitter or Transceiver & Splitter from the drop‐
down list.
 Calibrate Splitter to ‐ Select Serdes, QSFP or Serdes and QSFP from the drop‐
down list.
 Splitter Calibration ‐ Select Smart or Exhaustive from the drop‐down list.
10 GigE
Click the icon to display the Device Settings dialog. Select the Probe Calibration
Settings tab which has settings for Auto Calibration and Manual Calibration (see
Figure 2.46 on page 75 ).