Teledyne LeCroy SierraNet M408 User Manual Ver.1.40 - Manual (Page 215)

SierraNet M408 Protocol Analyzer User Manual 213
InFusion Scenarios LeCroy Corporation
But if the Event counters are set to 1 and the Action counter is set to 5, then the Action
happens after five occurrences of EITHER Event_1 or Event_2.
4.5.7 Capturing a Data Dword
InFusion provides the ability to capture individual data dwords and provides different
registers to store captured dwords. When your detector is DWord Matcher you can use
Dword #0, #1, #2 and #3 and when your detector is Pattern Detector you can use Dword
#4, #5, #6 and #7. When trying to use the captured dword, for example in Replace Dword
Action, you can actually select from 8 captured dwords, numbered 0 through 7.
To capture a data dword, select Capture Dword from the Action Properties screen (see
Figure 4.7 on page 213 ). Select the location you would like the captured Dword to be
stored in, so it can be used in a later replacement or insertion.
Figure 4.7: Capture Data Dword Action
4.5.8 Using Captured Data Dwords
Captured data dwords can be used in creating Events for data that match the captured
dword(s), or in creating Actions to substitute or insert the captured dword(s) into the data
stream.
To create an Event using the captured dword, in the Add Event dialog (see Figure 4.8 on
page 214 ), select Dword Matcher and change the Type to the desired Captured Dword
number. Note that choice of a mask and an offset are still available. Select the code mask
from the drop‐down menu.