Teledyne LeCroy Summit T3-16 PCIe Multi-lane Protocol Analyzer User Manual - Manual (Page 33)

Summit T3‐16 PCI Express Multi‐Lane Protocol Analyzer User Manual 21
Using Probes Teledyne LeCroy
Figure 3.17: Connecting MidBus Probe Connections
Connect the header on the MidBus probe assembly to the MidBus footprint on the
System Under Test (host platform or root complex under test). The following picture
shows two midbus footprints, with one connected to the MidBus probe assembly.
Figure 3.18: Connect MidBus Probe to MidBus Footprint
Connection Procedure
To connect the Summit T3‐16 to the System Under Test (host platform or root complex
under test:
1. Connect the MidBus pods to the Analyzer using the iPass Y‐cables.
2. Connect the MidBus probe assemblies to the MidBus pods.
3. Connect the MidBus probe assemblies to the MidBus footprints on the system under
test.