Teledyne LeCroy Summit T3-16 PCIe Multi-lane Protocol Analyzer User Manual - Manual (Page 76)

Teledyne LeCroy Link Settings
64 Summit T3‐16 PCI Express Multi‐Lane Protocol Analyzer User Manual
5.14.7 Ignore EDS
Lets the Analyzer ignore EDS. (see Figure 5.1 on page 54 : 3H.)
5.14.8 Ignore Idle Errors
When set analyzer will not store errors in between packets into memory. This option
helps to preserve analyzer memory to store more packets in cases where memory
efficiency is critical. This option filters out Compliance Pattern as well. (see
Figure 5.1 on
page 54 : 3I.)
5.14.9 Swizzling Config...
The Swizzling Config dialog allows you to reconfigure the order of the US (UpStream) and
DS (DownStream) lanes. Check the box to Auto‐Configure Lane Swizzle (see
Figure 5.1 on
page 54 : 3J).
Note: Autoswizzle works only when the analyzer sees the LTSSM Configuration state link training
sequence.
Figure 5.12: Swizzling Config Dialog
When the Auto‐Configure Lane Swizzle is checked, it is important to configure Lane 0. You
can do so by manually dragging Lane 0 to the required position. See
Figure 5.13 on
page 65 .