Teledyne LeCroy Summit Z3-16 PCI Express Multi-lane Exerciser User Manual User Manual
Page 27
Summit Z3‐16 PCI Express Multi‐Lane Exerciser User Manual
27
Setting Up the Summit Z3‐16 Exerciser using an Ethernet Connection
Teledyne LeCroy
Figure 3.7: Connection Properties Dialog
7. Select an option:
Automatically connect to the device: When the application is started or when
the named device is added to the network while the PETracer application is run‐
ning on this computer, the PETracer application will try to connect to the named
device.
Ask if I want to connect to the device: When the application is started or when
the named device is added to the network while the PETracer application is run‐
ning on this computer, the PETracer application will display a message box allow‐
ing you to connect to the named device.
Take no action: When you start the application or when you want to add the
named device to the network while the PETracer application is running on this
computer, you must connect manually to use the named device.
Note:
When you close the application on this computer (or you perform manual
disconnect), the application disconnects from the device.
8. Press OK in the Connection Properties dialog.
After you finish the connect procedure, the Summit device to which you have
connected is marked as Ready and you can use it for traffic generation (see
).