2 starting point, 2 ltssm control – Teledyne LeCroy Summit Z3-16 PCI Express Multi-lane Exerciser User Manual User Manual

Page 34

Advertising
background image

Teledyne LeCroy

LTSSM Control

34

 

 

Summit Z3‐16 PCI Express Multi‐Lane Exerciser User Manual

4.1.2

Starting Point

When the Exerciser first powers up, it is at electrical idle on all lanes. The link is not 
trained, but the LTSSM is enabled and waiting for a command to train the link. To begin 
communication with a PCI Express device, Link training must occur, but first the 
generation settings must be set. This involves setting the Link parameters such as link 
width, polarity inversion, and lane reversal, through the Generation Options dialog. 

Note:

Setting the options in the Generation Options dialog has no effect on the Exerciser behavior 

until the first script is executed. In fact, each time a script is executed, these behaviors are 
reprogrammed to the Exerciser and the behaviors are modified accordingly.

4.2 LTSSM

Control

The LTSSM Control button on the Summit Z3 Exerciser status toolbar 

 can be 

pressed to open the LTSSM Control dialog. In this dialog, you can initiate speed switches, 
initiate link width changes, initiate select link state changes, and run tests on the different 
arcs of the LTSSM.

Figure 4.1: LTSSM Control Dialog

ACTIVE
TEST

TEST 
DETAILS
PANE

LOG 
PANE

Advertising