Wan ip address – Actiontec electronic GT701A User Manual
Page 39
36
Actiontec USB/Ethernet DSL Modem User Manual
37
Chapter 4 Using Advanced Setup
4. In the next screen, read the recommendations. To perform an advanced setup
on the Modem, click Begin Advanced Setup.
5. The “Configuring the Advanced Settings” screen appears. To check all the set-
tings, or if unsure of which settings to modify, select Next. To modify a spe-
cific configuration, click on its name in the menu bar on the left.
☞
Note: To save changes made in any of the Advanced Setup
screens, click Save and Restart at the bottom of the gray menu
on the left side of the screen.
WAN IP Address
Selecting
WAN IP
Address in the “Configuring the Advanced Settings” screen gen-
erates the “
WAN IP
Address” screen.
WAN IP
Address allows manual set up of the
IP address of the Modem. There are five ways to do this: Transparent Bridging,
Obtain an
IP
Address through
PPP
o
E
, Obtain an
IP
Address Through
PPPoA
,
Obtain an IP Address through
DHCP
, and Specify a Static
IP
Address.
☞
Note: If unsure about which connection is present, check with
the Internet Service Provider (
ISP)
before continuing.