Actiontec electronic GT701A - Manual (Page 9)

6
Actiontec USB/Ethernet DSL Modem User Manual
USB Port
The
USB port is used to connect a computer to the Modem via USB cable.
☞
Note: It is not recommended to perform a recovery or update
for the Modem from a computer connected via USB .
Ethernet Port
The Ethernet port is used to connect computers to the Modem via Ethernet
cable. The Ethernet port is a
10/100 Mbps auto-sensing port, and either a
straight-through or crossover Ethernet cable can be used when connecting to
the port.
Power Port
The Power port is used to connect the Power cord to the Modem.
N
Warning: Do not unplug the Power cord from the Modem dur-
ing the reset process. Doing so may result in permanent damage
to the Modem.
Reset Switch
Depressing the Reset switch for one or two seconds will power cycle the Modem
(similar to unplugging and then plugging in the Modem’s Power cord). To
restore the Modem’s factory default settings, depress and hold the Reset switch
for approximately
15 seconds. The reset process will start about 10 seconds after
releasing the switch.
Power Switch
The Power switch is used to power the Modem on and off.
N
Warning: Do not click the Power switch to its “off” postion
during the reset process. Doing so may result in permanent
damage to the Modem.