Oven service procedures, Conveyor control programming procedure – XLT XD-9007A (ELEC Oven Version – B1, AVI Hood Version – B) User Manual
Page 18

18
Technical Support US: 888-443-2751
Technical Support INTL: 316-943-2751
Conveyor Control Programming Procedure
OVEN SERVICE PROCEDURES
Read the entire instruction before programming.
Configuration Key Functions
< L > =
Behind the <L> in XLT is a hidden button. This is used along with the up and down button to ac-
cess the programming mode. Use this after each step to advance to the next parameter when pro-
gramming.
UP =
Increases the setting of the selected parameter.
Down =
Decrease the setting of the selected parameter.
1. Enter Programming Mode/ Program the bake length
Press the <L> button and both <UP> and <DOWN> button simultaneously to enter programming mode.
(You will be in bake length programming mode)
0055 will appear on screen, this is already set from factory
Press the <UP> button until the desired belt length is displayed for your application. Belt lengths will
read as follows:
1832 = 0032
1855 = 0055
2440 = 0040
3240 = 0040
3255 = 0055
3270 = 0070
3855 = 0055
3870 = 0070
3. Program the Total Reduction Value
Press the <UP> button until the desired settings is reached.
All ovens = 300.
4. Set Speed Trimming Value
Press the <DOWN> button until the display shows 0000.
5. Set Fast Bake Limit
Press the <UP> button until the display shows 1:30.
6. Set Slow Bake Limit
Press the <UP> button until the display shows 17:00.
7. Set Conveyor Motor Rotation
Press the <UP> OR <DOWN> buttons until the display shows 1 for right-to-left direction, or 2 for left-to
-right belt direction.
8. Save and Exit Programming Mode
Press the <L> button two times to save and exit Programming Mode.
9. 1:30 run time will appear
Press and hold the <UP> or <DOWN> buttons until desired run time appears.