XLT XD-9007A (ELEC Oven Version – B1, AVI Hood Version – B) - Manual (Page 19)

19
Technical Support US: 888-443-2751 Technical Support INTL: 316-943-2751
Temperature Control Programming Procedure
OVEN SERVICE PROCEDURES
Configuration Key Functions
<FUNC> =
The new setting of the selected parameter is stored
and the display advances to the next parameter. This
is required between each parameter.
= Increases the setting of the selected parameter.
= Decrease the setting of the selected parameter.
1. Open V101 switch for Basic Configuration (Figure 1)

Turn main switch to the off position

Remove instrument from its case

Open Switch V101

Re-insert the instrument back in its case.

Turn main switch to the on position
2. Basic Configurations

Using the configuration keys scroll thru parameter codes
changing them to match (Figure 2)

After P12 _._._._. Will appear
3. Close V101 switch after Basic Configuration (Figure 1)

Remove instrument from its case

Close Switch V101

Re-insert the instrument back in its case.

Error 400 will appear press and hold the and to clear

000 will appear
4. Advanced Configurations Procedure

Using the configuration keys scroll thru parameter codes
Changing them to match (Figure 3)

On the first pass thru change nnn to 311 to unlock the
advanced configuration

Scroll thru the parameter codes again and change the nnn to 5
this locks the advanced configuration

Scroll thru the parameter codes again and verify nnn is ON
SP
260˚C/500˚F
nnn 311/5
AL
315˚C/600˚F
HSA .1
Pb 4.0
ti 5.0
td .00
1P 30
C 2
rL
204˚C/400˚F
rH
310˚C/590˚F
OLH 100
tOL InF
Read the entire instruction before programming.
P1
2˚C/10˚F
P2 0
P3
315˚C/600˚F
P4 r
P5 1
P6 H.A.
P7 d
P8 OFF
P9 0
P10 100
P11 311
P12 7
Figure 2