IEI Integration KINO-945GSE v1.10 - Manual (Page 84)

KINO-945GSE Motherboard
Page 68
Before and during the installation of the KINO-945GSE DO NOT:
ƒ DO NOT remove any of the stickers on the PCB board. These stickers are
required for warranty validation.
ƒ DO NOT use the product before verifying all the cables and power connectors
are properly connected.
ƒ DO NOT allow screws to come in contact with the PCB circuit, connector pins,
or its components.
5.2.2 Installation Checklist
The following checklist is provided to ensure the KINO-945GSE is properly installed.
ƒ All the items in the packing list are present
ƒ A compatible memory module is properly inserted into the slot
ƒ The CF Type I or CF Type II card is properly installed into the CF socket
ƒ The jumpers have been properly configured
ƒ The KINO-945GSE is inserted into a chassis with adequate ventilation
ƒ The correct power supply is being used
ƒ The following devices are properly connected
o Primary and secondary IDE device
o SATA drives
o Power supply
o USB cable
o Serial port cable
ƒ The following external peripheral devices are properly connected to the
chassis:
o VGA screen
o Keyboard
o Mouse
o RS-232 serial communications device
o USB devices
5.3 Unpacking
When the KINO-945GSE is unpacked, please check all the unpacking list items listed in
Chapter 3 are indeed present. If any of the unpacking list items are not available please