2 sata drive connection, Figure 5-10: sata drive cable connection – IEI Integration KINO-945GSE v1.10 User Manual
Page 97
KINO-945GSE Motherboard
Page 81
5.8.2 SATA Drive Connection
The KINO-945GSE is shipped with two SATA drive cables and one SATA drive power
cable. To connect the SATA drives to the connectors, please follow the steps below.
Step 1:
Locate the connectors. The locations of the SATA drive connectors are shown
in Chapter 3.
Step 2:
Insert the cable connector. Press the clip on the connector at the end of the
SATA cable and insert the cable connector into the onboard SATA drive
connector. See
8
Figure 5-10.
Figure 5-10: SATA Drive Cable Connection
Step 3:
Connect the cable to the SATA disk. Connect the connector on the other end
of the cable to the connector at the back of the SATA drive. See
8
Figure 5-11.
Step 4:
Connect the SATA power cable. Connect the SATA power connector to the
back of the SATA drive. See
8
Figure 5-11.
Step 4: