IEI Integration KINO-945GSE v1.10 - Manual (Page 87)

KINO-945GSE Motherboard
Page 71
Figure 5-2: CF Card Installation
5.6 Jumper Settings
NOTE:
A jumper is a metal bridge used to close an
electrical circuit. It consists of two or three
metal pins and a small metal clip (often
protected by a plastic cover) that slides over
the pins to connect them. To CLOSE/SHORT
a jumper means connecting the pins of the
jumper with the plastic clip and to OPEN a
jumper means removing the plastic clip from a
jumper.
Jumper Locations