IEI Integration KINO-945GSE v1.10 - Manual (Page 96)

KINO-945GSE Motherboard
Page 80
5.8.1 ATA Flat Cable Connection
The ATA 66/100 flat cable connects to the KINO-945GSE to one or two IDE devices. To
connect an IDE HDD to the KINO-945GSE please follow the instructions below.
Step 4: Locate the IDE connector. The location/s of the IDE device connector/s is/are
shown in Chapter 3.
Step 5: Insert the connector. Connect the IDE cable connector to the onboard
connector. See
8
Figure 5-9. A key on the front of the cable connector ensures it
can only be inserted in one direction.
Figure 5-9: IDE Cable Connection
Step 6: Connect the cable to an IDE device. Connect the two connectors on the other
side of the cable to one or two IDE devices. Make sure that pin 1 on the cable
corresponds to pin 1 on the connector. Step 0: