IEI Integration KINO-PVN-D4251_D5251 - Manual (Page 57)

KINO-PVN-D5251/D4251/ Mini ITX SBC
Page 43
4.6 Jumper Settings
NOTE:
A jumper is a metal bridge used to close an
electrical circuit. It consists of two or three
metal pins and a small metal clip (often
protected by a plastic cover) that slides over
the pins to connect them. To CLOSE/SHORT
a jumper means connecting the pins of the
jumper with the plastic clip and to OPEN a
jumper means removing the plastic clip from a
jumper.
Before the KINO-PVN-D5251/D4251 is installed in the system, the jumpers must be set in
accordance with the desired configuration. The jumpers on the KINO-PVN-D5251/D4251
are listed in
6
Table 4-1.
Description Type Label
AT/ATX Power setting 3-pin wafer ATXCTL1
Clear CMOS 3-pin header J_CMOS1
CompactFlash® setting 2-pin header JCF1
Serial port setting 8-pin header JP3
Table 4-1: Jumpers
4.6.1 AT/ATX Power Select Jumper Settings
Jumper Label: ATXCTL1
Jumper Type: 3-pin header (1x3)
Jumper Settings: See Table 4-2
Jumper Location: See Figure 4-4