IEI Integration IMBA-Q454 v1.01 - Manual (Page 70)

IMBA-Q454-R10 User Manual
Page 70
4.3.3 DIMM Installation
WARNING:
Using incorrectly specified memory modules may cause permanent
damage the IMBA-Q454-R10. Please make sure the memory modules
comply with the recommended memory specifications.
WARNING:
1) Before removing the DDR2 DRAM module, make sure the AC power
supply is completely turned off. Incorrect usage may cause permanent
damage to the IMBA-Q454 or the DRAM module because the
IMBA-Q454 supports the iAMT feature which provides power to the
DRAM module when the IMBA-Q454 is off.
2) Do not disconnect the ATX connector when the IMBA-Q454 power is
on. Please make sure to switch off the ATX power supply prior to
disconnecting the ATX connector. Incorrect usage may cause
permanent damage to the IMBA-Q454.
3) If the IMBA-Q454 fails to boot due to improper usage, please clear
the CMOS by disconnecting the battery from the connector.
To install a DIMM, please follow the steps below and refer to
8
Figure 4-7.