IEI Integration IMBA-G412ISA v2.00 - Manual (Page 69)

2012/1/202012/1/20
IMBA-G412IS A ATX Mo th e rb o a rd
P a g e 55
Figure 4-13: USB Power Select Jumper Location
4.5 In te rn a l P e rip h e ra l De vic e Co n n e c tio n s
This section outlines the installation of peripheral devices to the onboard connectors.
4.5.1 S ATA Drive Co n n e c tio n
The IMBA-G412ISA is shipped with two SATA drive cables and one SATA drive power
cable. To connect the SATA drives to the connectors, please follow the steps below.
S te p 1: Locate the connectors. The locations of the SATA drive connectors are shown
in Chapter 3.
S te p 2: Insert the cable connector. Press the clip on the connector at the end of the
SATA cable and insert the cable connector into the on-board SATA drive
connector. See Figure 4-14.