4 internal peripheral device connections, 1 sata drive connection, Nternal – IEI Integration IMBA-Q770 User Manual
Page 76: Eripheral, Evice, Onnections, Figure 4-14: sata drive cable connection
IMBA-Q770 ATX Motherboard
Page 61
4.4 Internal Peripheral Device Connections
This section outlines the installation of peripheral devices to the onboard connectors.
4.4.1 SATA Drive Connection
The IMBA-Q770 is shipped with four SATA drive cables. To connect the SATA drives to
the connectors, please follow the steps below.
Step 1:
Locate the connectors. The locations of the SATA drive connectors are shown
in Chapter 3.
Step 2:
Insert the cable connector. Insert the cable connector into the on-board SATA
drive connector until it clips into place. See Figure 4-14.
Figure 4-14: SATA Drive Cable Connection
Step 3:
Connect the cable to the SATA disk. Connect the connector on the other end
of the cable to the connector at the back of the SATA drive. See Figure 4-15.
Step 4:
Connect the SATA power cable (optional). Connect the SATA power
connector to the back of the SATA drive. See Figure 4-15.