IEI Integration IMBA-Q770 - Manual (Page 79)

IMBA-Q770 ATX Motherboard
Page 64
Step 3: Insert the DVI-I connector . Once the connectors are properly aligned with the
male connector, insert the male connector from the digital display device into the
female connector on the IMBA-Q770. See Figure 4-17.
Figure 4-17: DVI-I Connection
Step 4: Secure the connector. Secure the DVI-I connector from the digital display
device to the external interface by tightening the two retention screws on either
side of the connector. Step 0:
4.5.3 HDMI Display Device Connection
The HDMI connector transmits a digital signal to compatible HDMI display devices such
as a TV or computer screen. To connect the HDMI cable to the IMBA-Q770, follow the
steps below.
Step 1: Locate the HDMI connectors. The locations are shown in Chapter 3.
Step 2: Align the connector. Align the HDMI connector with the HDMI port. Make sure
the orientation of the connector is correct.