IEI Integration NANO-LX v1.00 - Manual (Page 80)

80 IEI ® Technology, Corp.
PIN DESCRIPTION PIN DESCRIPTION
1 KB Data 2 MS_DATA
3 GND 4 +5V
5 Clock 6 MS_CLK
Table 3-35: CN31 Pinouts
Figure 3-31: CN31 Pinout locations
NOTE:
A jumper is a metal bridge used to close
an electrical circuit. It consists of two or
three metal pins and a small metal clip
(often protected by a plastic cover) that
slides over the pins to connect them. To
CLOSE/SHORT a jumper means
connecting the pins of the jumper with
the plastic clip and to OPEN a jumper
means removing the plastic clip from a
jumper.
Figure 3-32: Jumper Locations
3.4 Onboard Jumpers
The NANO-LX CPU Board has seven onboard jumpers (Table 3-3).