IEI Integration NANO-LX v1.00 - Manual (Page 93)

NANO-LX CPU Card
93
4.3.3 Airflow Consideration
Although the embedded board can operate without active cooling, it is still necessary to
install the board in a chassis with ventilation holes on the sides allowing airflow to travel
through the heat sink surface. In a system with an individual power supply unit, the cooling
fan of a power supply can also help generate airflow through the board surface.
4.3.4 Peripheral Device Connection
Cables provided by IEI that connect peripheral devices to the CPU card are listed in
Table 4-1. Cables not included in the kit must be purchased separately.
Quantity Type
1 IDE flat cable 44p/44p
1 Keyboard/ PS2 mouse cable
2 SATA cable
1 SATA power cable
1 Audio cable
2 2.0 Pitch Single RS-232 port cable W/O BK
Table 4-1: IEI Provided Cables
4.3.4.1 IDE Disk Drive Connector
The cable used to connect the motherboard to the IDE HDD is a standard 44-pin
ATA 66/100 flat cable. To connect an IDE HDD to the motherboard, follow the instructions
below.
Step 1:
Step 2:
Step 3:
Step 4:
Find the ATA 66/100 flat cable in the kit that came with the motherboard.
Connect one end of the cable to the IDE1 connector on the motherboard. A
keyed pin on the IDE connectors prevents it from being connected incorrectly.
Locate the red wire on the other side of the cable that corresponds to the pin
1 connector.
Connect the other side of the cable to the HDD making sure that the pin 1 cable
corresponds to pin 1 on the connector. Step 0: