IEI Integration NOVA-945GSE v2.01 - Manual (Page 82)

NOVA-945GSE 5.25” SBC
Page 80
with the USB connectors on the NOVA-945GSE, connect the cable connectors
to the on-board connectors. See Figure 4-15.
Figure 4-15: Dual USB Cable Connection
Step 4: Attach the USB connectors to the chassis. The USB 2.0 connectors each of
two retention screw holes. To secure the connectors to the chassis please refer
to the installation instructions that came with the chassis. Step 0:
4.8 External Peripheral Interface Connection
The following external peripheral devices can be connected to the external peripheral
interface connectors.
RJ-45 Ethernet cable connectors
To install these devices, connect the corresponding cable connector from the actual
device to the corresponding NOVA-945GSE external peripheral interface connector
making sure the pins are properly aligned.