IEI Integration PM-945GSE - Manual (Page 57)

PM-945GSE-N270 User Manual
Page 57
Step 1: Turn the CPU board over so that the CF Type II card socket is facing up.
Step 2: Gently push the CF Type II card into the socket until it clicks into place. (See
Figure 4-1)
Figure 4-1: CompactFlash® Card Installation
4.5 Jumper Settings
NOTE:
A jumper is a metal bridge that is used to
close an electrical circuit. It consists of two
metal pins and a small metal clip (protected by
a plastic cover) that slides over the pins to
connect them. To CLOSE/SHORT a jumper
means connecting the pins of the jumper with
the plastic clip and to OPEN a jumper means
removing the plastic clip from a jumper.
Jumper