IEI Integration PM-945GSE - Manual (Page 92)

PM-945GSE-N270 User Manual
Page 92

1 D EFAULT System is remotely accessed through COM1

2 System is remotely accessed through COM2

3 System is remotely accessed through COM3

4 System is remotely accessed through COM4
NOTE: Make sure the selected COM port is enabled through the Super I/O configuration
menu.
 Base Address, IRQ [3F8h,4]
The Base Address, IRQ option cannot be configured and only shows the interrupt
address of the serial port listed above.
 Serial Port Mode [115200 8,n,1]
Use the Serial Port Mode option to select baud rate through which the console redirection
is made. The following configuration options are available
 115200 8,n,1 D EFAULT
 57600 8,n,1
 38400 8,n,1
 19200 8,n,1
 09600 8,n,1
NOTE:
Identical baud rate setting musts be set on the host (a management
computer running a terminal software) and the slave
 Redirection After BIOS POST [Always]
Use the Redirection After BIOS POST option to specify when console redirection should
occur.