IEI Integration WAFER-945GSELVDS2 - Manual (Page 79)

WAFER-945GSELVDS2
Page 67
WARNING:
When running the WAFER-945GSELVDS2, do not put the
WAFER-945GSELVDS2 directly on a surface that can not dissipate
system heat, especially the wooden or plastic desk. It is highly
recommended to run the WAFER-945GSELVDS2
Æ on a heat dissipation surface or
Æ using copper pillars to hold the board up from the desk below
When the WAFER-945GSELVDS2 is shipped it is secured to a heat sink with five
retention screws. If the WAFER-945GSELVDS2 must be removed from the heat sink, the
five retention screws must be removed.
Figure 4-21: Heat Sink Retention Screws
4.11 Installing Drivers
To access the driver installation programs, please do the following.