IEI Integration WAFER-CV-D25502_N26002 - Manual (Page 63)

WAFER-CV-D25502/N26002 3.5" Motherboard
Page 48
Figure 4-6: Connect Power Cable to Power Supply
4.5.2 Audio Kit Installation
The Audio Kit that came with the WAFER-CV-D25502/N26002 connects to the 10-pin
audio connector on the WAFER-CV-D25502/N26002. The audio kit consists of three
audio jacks. One audio jack, Mic In, connects to a microphone. The remaining two audio
jacks, Line-In and Line-Out, connect to two speakers. To install the audio kit, please refer
to the steps below:
Step 1: Locate the audio connector. The location of the 10-pin audio connector is
shown in Chapter 3.
Step 2: Align pin 1. Align pin 1 on the on-board connector with pin 1 on the audio kit
connector. Pin 1 on the audio kit connector is indicated with a white dot. See
7
Figure 4-7.