IEI Integration WAFER-CV-D25502_N26002 - Manual (Page 76)

WAFER-CV-D25502/N26002 3.5" Motherboard
Page 61
4.6.4 VGA Monitor Connection
The WAFER-CV-D25502/N26002 has a single female DB-15 connector on the external
peripheral interface panel. The DB-15 connector is connected to a CRT or VGA monitor.
To connect a monitor to the WAFER-CV-D25502/N26002, please follow the instructions
below.
Step 1: Locate the female DB-15 connector. The location of the female DB-15
connector is shown in Chapter 3.
Step 2: Align the VGA connector. Align the male DB-15 connector on the VGA screen
cable with the female DB-15 connector on the external peripheral interface.
Step 3: Insert the VGA connector . Once the connectors are properly aligned with the
insert the male connector from the VGA screen into the female connector on the
WAFER-CV-D25502/N26002. See
7
Figure 4-20.
Figure 4-20: VGA Connector
Step 4: Secure the connector. Secure the DB-15 VGA connector from the VGA
monitor to the external interface by tightening the two retention screws on either
side of the connector.