IEI Integration WAFER-CV-D25502_N26002 - Manual (Page 70)

WAFER-CV-D25502/N26002 3.5" Motherboard
Page 55
Step 3: Connect the cable to the SATA disk. Connect the connector on the other end
of the cable to the connector at the back of the SATA drive. See
7
Figure 4-14.
Step 4: To remove the SATA cable from the SATA connector, press the clip on the
connector at the end of the cable.
4.5.7 Single RS-232 Cable
The single RS-232 cable consists of one serial port connector attached to a serial
communications cable that is then attached to a D-sub 9 male connector. To install the
single RS-232 cable, please follow the steps below.
Step 1: Locate the connector. The locations of the RS-232 connectors are shown in
Chapter 3.
Step 2: Insert the cable connector. Insert the connector into the serial port header.
See
7
Figure 4-15. A key on the front of the cable connector ensures the
connector can only be installed in one direction.
Figure 4-15: Single RS-232 Cable Installation
Step 3: Secure the bracket. The single RS-232 connector has two retention screws
that must be secured to a chassis or bracket.