IEI Integration WAFER-CV-D25502_N26002 - Manual (Page 71)

WAFER-CV-D25502/N26002 3.5" Motherboard
Page 56
Step 4: Connect the serial device. Once the single RS-232 connector is connected to
a chassis or bracket, a serial communications device can be connected to the
system.
4.5.8 Keyboard/Mouse Y-cable Connector
The WAFER-CV-D25502/N26002 is shipped with a keyboard/mouse Y-cable connector.
The keyboard/mouse Y-cable connector connects to a keyboard/mouse connector on the
WAFER-CV-D25502/N26002 and branches into two cables that are each connected to a
PS/2 connector, one for a mouse and one for a keyboard. To connect the keyboard/mouse
Y-cable connector, please follow the steps below.
Step 1: Locate the connector. The location of the keyboard/mouse Y-cable connector
is shown in Chapter 3.
Step 2: Align the connectors. Correctly align pin 1 on the cable connector with pin 1 on
the WAFER-CV-D25502/N26002 keyboard/mouse connector. See
7
Figure 4-16.
Step 3: Insert the cable connectors . Once the cable connector is properly aligned with
the keyboard/mouse connector on the WAFER-CV-D25502/N26002, connect
the cable connector to the on-board connector. See
7
Figure 4-16.