IEI Integration WAFER-CV-D25502_N26002 - Manual (Page 74)

WAFER-CV-D25502/N26002 3.5" Motherboard
Page 59
4.6.2 Serial Device Connection
The WAFER-CV-D25502/N26002 has a single male DB-9 connector on the external
peripheral interface panel for a serial device. Follow the steps below to connect a serial
device to the WAFER-CV-D25502/N26002.
Step 1: Locate the DB-9 connector. The location of the DB-9 connector is shown in
Chapter 3.
Step 2: Insert the serial connector. Insert the DB-9 connector of a serial device into
the DB-9 connector on the external peripheral interface. See
7
Figure 4-18.
Figure 4-18: Serial Device Connector
Step 3: Secure the connector. Secure the serial device connector to the external
interface by tightening the two retention screws on either side of the connector.