IEI Integration uIBX-200-VX800 v2.00 - Manual (Page 61)

uIBX-200-R20/VX800 Embedded System
Page 51
ƒ Serial Port Number [COM1]
Use the Serial Port Number option allows to select the serial port used for remote
access.
Î
COM1 D EFAULT
System is remotely accessed through COM1
Î
COM2 System is remotely accessed through COM2
NOTE : Make sure the selected COM port is enabled through the Super I/O configuration
menu.
ƒ Base Address, IRQ [3F8h,3]
The Base Address, IRQ option cannot be configured and only shows the interrupt
address of the serial port listed above.
ƒ Serial Port Mode [115200 8,n,1]
Use the Serial Port Mode option to select baud rate through which the console redirection
is made. The following configuration options are available
ƒ 115200 8,n,1 D
EFAULT
ƒ 57600 8,n,1
ƒ 38400 8,n,1
ƒ 19200 8,n,1
ƒ 09600 8,n,1
NOTE:
Identical baud rate setting musts be set on the host (a management
computer running a terminal software) and the slave
ƒ Redirection After BIOS POST [Always]
Use the Redirection After BIOS POST option to specify when console redirection should
occur.