IEI Integration TANK-720-Q67 - Manual (Page 34)

TANK-720 Em b e d d e d S ys te m
P a g e 22
3.7 S O-DIMM In s ta lla tio n
WARNING:
Using incorrectly specified SO-DIMM may cause permanently damage
the TANK-720. Please make sure the purchased SO-DIMM complies
with the memory specifications of the TANK-720.
To install a SO-DIMM into a SO-DIMM socket, please follow the steps below.
S te p 1: Remove the bottom panel by removing the 10 retention screws from the bottom
panel (Figure 3-1).
S te p 2: Remove the eight retention screws (Figure 3-9), unplug the SATA signal and
power cables connected to the TANK-720, and then lift the bracket out of the
TANK-720.
Figure 3-9: Retention Screws
S te p 3: Locate the SO-DIMM socket on the motherboard (Figure 3-10).