IEI Integration ECN-780-Q67 - Manual (Page 32)

ECN-780-Q67 Em b e d d e d S ys te m
P a g e 19
S te p 2: Align the two retention screw holes in each bracket with the corresponding
retention screw holes on the sides of the bottom surface.
S te p 3: Secure the brackets to the system by inserting two retention screws into each
bracket as illustrated in Figure 3-8.
Figure 3-8: Mounting Bracket Retention Screws
S te p 4: Drill holes in the intended installation surface.
S te p 5: Align the mounting holes in the sides of the mounting brackets with the predrilled
holes in the mounting surface.
NOTE:
Please make sure to face the I/O panel sideward (Figure 3-8) when
mounting the system.
S te p 6: Insert four retention screws, two in each bracket, to secure the system to the
wall. S te p 0: