IEI Integration PPC-51xxA-H61 - Manual (Page 45)

PPC-51xxA-H61 Panel PC
Page 30
3.7 Drive Installation
The drive installation process is shown in the sections below.
3.7.1 Hard Drive Installation
To install a HDD, please follow the steps below:
Step 1: Remove the back cover (Section
7
3.5 ).
Step 2: The HDD bracket is attached to the elevated platform by four retention screws.
Remove the four retention screws from the elevated platform (
7
Figure 3-4 ).
Figure 3-4: HDD Bracket Retention Screws
Step 3: Attach the hard drive in the bracket. To do this, slide the hard drive onto the
bracket until it connects with the SATA connector at the back. Fasten the four
retention screws on the side.