IEI Integration PPC-51xxA-H61 - Manual (Page 65)

PPC-51xxA-H61 Panel PC
Page 50
NOTE:
When purchasing the arm please ensure that it is VESA compliant and
that the arm has a 100 mm interface pad. If the mounting arm is not
VESA compliant, it cannot be used to support the PPC-51xxA-H61
panel PC.
Step 2: Once the mounting arm has been firmly attached to its surface, lift the
PPC-51xxA-H61 panel PC onto the interface pad of the mounting arm.
Step 3: Align the retention screw holes on the mounting arm interface with those in the
PPC-51xxA-H61 panel PC. The arm mounting retention screw holes of the
PPC-51xxA-H61 panel PC are shown in Figure 3-30.
Figure 3-30: Arm Mounting Retention Screw Holes
Step 4: Secure the PPC-51xxA-H61 to the interface pad by inserting four retention
screws through the mounting arm interface pad and into the PPC-51xxA-H61
panel PC.
Step 0:
3.11.5 Stand Mounting
To mount the PPC-51xxA-H61 using the stand mounting kit, please follow the steps
below.